The purpose of this course is to submit the understanding of well control techniques for surface and subsea BOP installations at driller level according to new International Association of Drilling Contractors (IADC) WellSharp standards.
Book her
UKE
DATO
STED
PRIS
UKE
DATO
STED
PRIS
Har du noen spørsmål?
Lurer du på noe angående IADC WellSharp Driller Level?
Send inn ditt spørsmål i skjema under, så kommer vi tilbake til deg så fort som mulig.
This course is offered in Norwegian but can be delivered in English if requested.
Course Content
The course covers the following areas:
Well control awareness
Basic well control concepts
Mud and it management
Pre-recorded data
Causes of kicks
Barriers
Shallow gas, shallow water flows and top-hole drilling
Abnormal pressure warning signs
Well control drills
Kick detection
Shut-in pressures and verification
Post-shut in monitoring and activities
Well control methods
Casing and cementing considerations
Risk management
Surface well control equipment
Subsea well control equipment
Simulator and written examinations
Course Objectives
Understand and apply the principles and procedures used in well control operations with Surface or Subsea BOP stacks.
Use the equipment for well control operations with surface or subsea BOP stack.
Increase well control understanding by use of the simulators.
Show that kick detection and initial reaction can be mastered by use of simulators.
Obtain sufficient knowledge about the course content to pass three tests with minimum 70% score on each.
